Walk Behind Floor Scrubber Machine

It's designed for cleaning and drying large indoor hard-floor areas in commercial and industrial settings such as warehouses, shopping malls, schools, hospitals and airports.

Key specs: weight 76 kg, power 880 W, rated voltage DC 24V, working width 400 mm (brush) / 580 mm (squeegee), working efficiency 1600 m²/h, brush RPM 180, brush/vacuum motors 380 W / 500 W, solution/recovery tanks 25 L / 30 L, storage batteries 46 AH × 2, continuous run time 2–2.5 hours, noise ≤65 dB(A).

CIP indicates the machine's tanks and internal recovery/solution pathways can be rinsed and cleaned without full disassembly, simplifying maintenance and sanitation.

It works well on hard floors: sealed concrete, tile, vinyl, linoleum, terrazzo and sealed wood. It is not intended for deep carpet cleaning.

The machine uses two storage batteries rated 46 AH each at DC 24V. Typical continuous working time is about 2–2.5 hours, depending on operating conditions and settings.

Rated working efficiency is about 1600 m² per hour. Actual productivity will vary with overlap, obstacles, operator technique and floor conditions.

Noise level is rated at 65 dB(A) or below, making it relatively quiet for commercial floor cleaning.

Daily: empty and rinse recovery tank, clean filters, inspect and rinse solution tank, check and clean squeegee and brushes/pads. Weekly/monthly: inspect hoses, check battery water (if applicable), tighten fasteners, and replace worn squeegee blades or brush pads as needed.

Common accessories/consumables include brushes and pads, squeegee blades, recovery/solution filters, batteries, chargers, and vacuum motor parts. Check with your supplier for compatible parts.

Wear appropriate PPE, remove large debris before scrubbing, avoid using flammable cleaning agents, ensure proper battery charging/handling, do not operate on steep slopes, and follow manufacturer instructions for safe operation.

Charge batteries; fill solution tank with recommended cleaning solution; check brush/pad and squeegee installation; power on, set desired water/brush settings; perform a short test pass and adjust squeegee angle for proper pickup.

Use the rated efficiency (1600 m²/h) as a baseline. Estimated time = total area (m²) ÷ 1600, then add time for battery changes, refilling solution, and obstacles. Real-world time will be longer due to overlap and breaks.

Machine dimensions are 880 mm × 580 mm × 680 mm. Single package size is 92 × 52 × 82 cm with a single gross weight of approximately 80 kg.

Warranty and service terms are not specified in the product description. Contact your supplier or manufacturer for warranty length, coverage details and local service options.

The specified cleaning process is cold water cleaning. Do not use hot water or steam unless the manufacturer explicitly confirms compatibility to avoid damage to components and seals.